Table of Contents
Advertisement
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Removing cartridge group
Removing the compressor casing internal part
Remove two studs (74029 / 74026) at the point where the lifting device
(90190) will be fitted later.
Using press-off screws (90900), push apart the compressor casing in-
ternal part (76000) until the lifting device (90190/90195) can be at-
tached.
Slightly lift and then withdraw the compressor casing internal part in-
cluding the wall insert and diffuser.
Attach the support angle (90025) using screws (90021) and nuts
(74027).
Put down the compressor casing internal part including the wall insert
and diffuser on the support angle and an underlay.
Remove the O-ring (76040).
Operation Manual / TPL76-C
8
8.5
Page 97
Advertisement
Table of Contents
