Table of Contents
Advertisement
CAUTION
CAUTION
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Dismantling and installing the turbine
diffuser and nozzle ring
Removing the nozzle ring
Bend up the locking plates (56018), undo screws (56019) and remove.
Pull out nozzle ring.
Fastening the nozzle ring
When fitting the nozzle ring, new screws (56019) and locking plates
(56018) from the customer spare part set (97070) must be used.
Clogged partial areas on the nozzle ring
If a nozzle ring is found to be clogged over partial areas or covered by
loose parts, it is recommended that you have a turbine blade inspection
including a crack inspection carried out by an ABB Turbocharging Ser-
vice Station.
Operation Manual / TPL76-C
8
8.6
Page 105
Advertisement
Table of Contents
