Table of Contents
Advertisement
NOTICE
CAUTION
© Copyright 2016 ABB. All rights reserved.
Maintenance
Cleaning the filter silencer
Fitting filter silencer
Assemble insert units (E) by putting fleece segments (81136) into
sheet-metal cover (81137).
Bend back sheet-metal cover (81137) to original shape.
Put insert units (E) into slot guides in filter silencer body (81135).
If a cleaning container is fitted to the filter silencer (optional depending
on turbocharger type), the water injection line must now be refitted.
(See also following section Fitting cleaning pipe.)
Put cover grids (81266) uniformly into correct position.
Push connecting rods (81269) through clips on cover grids (81266).
If the connecting rods (81269) are not located correctly in their recesses
on the filter silencer body (81135), the cover grids (81266) can twist and
shift. There is then a risk of foreign matter and dirt getting into the com-
pressor.
Join connecting rods (81269) using screws (81272). When tightening
the screws (81272), ensure that connecting rods (81269) are located
correctly in recesses in filter silencer body (81135). Now tighten
screws (81272) alternately until the following maximum torque is
reached:
Operation Manual / TPL76-C
5
5.2
Page 54
Advertisement
Table of Contents
