ABB HT568005 Operation Manual page 62

5.3.2
NOTICE
Operating the water
pressure vessel
© Copyright 2016 ABB. All rights reserved.
Maintenance
Cleaning the compressor during
operation
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for compressor cleaning with XC3
In order to carry out a successful cleaning procedure that has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisite must be met:
Engine load 50 – 85%

Start cleaning cycle according to following description Wet cleaning

operation with XC3.
Operating procedure for compressor wet cleaning with XC3
The operating state prerequisites for compressor cleaning with XC3

must be fulfilled.
Remove sealing plug (X).

Fill vessel with required volume of clean water (see table Cleaning pa-

rameters).
Operation Manual / TPL76-C
5
5.3 Page 60