Removing Memory Module - HP xw8400 Service And Technical Reference Manual

Removing memory module

1. Disconnect power from the system (
access panel
facing up.
CAUTION
installation, power off the workstation and unplug the power cord from the AC power outlet.
Wait until the LED on the back of the power supply turns off before removing memory. If you
do not unplug the power cord while installing memory, your memory modules might be
damaged and the system will not recognize the memory changes.
2. Press the green tab at the base of the memory fan (1) and lift it up (2) to expose the memory
modules.
Figure 4-13
3. Gently push out on the socket levers.
66 Chapter 4 Removal and replacement procedures
(Access panel on page
To ensure that memory modules are not damaged during removal or
Rotating the memory fan
Pre-disassembly procedures on page
58). Place the workstation on its side with the system board
53), and remove the
ENWW