HP xw8400 Service And Technical Reference Manual page 35

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading Option
Power-On
Password
Password
Options
Smart Cover
Device Security
Network
Service Boot
System IDs
ENWW
Description
NOTE If the setup password is set, you must enter Computer Setup (F10) Utility to
change it, flash the ROM, and make changes to certain plug-and-play settings under
Windows.
Enables you to set and enable the power-on password.
Lock Legacy Resources
Prevents the operating system from reassigning plug-and-play resources for serial, parallel, and
floppy legacy I/O devices.
Network Server Mode
Enable or disable Network Server Mode, which enables the workstation to boot the operating
system when the power-on password is enabled with or without a keyboard or mouse attached.
When attached to the system, the keyboard and mouse remain locked until the power-on password
is entered.
Password Prompt on Warm Boot
Sets the Password Prompt on Warm Boot function. If disabled, the BIOS will only prompt for a
password after power-on
Enables you to disable cover removal sensor or to notify the user if the sensor has been activated.
If disabled, the BIOS will only prompt for a password after power-on.
Makes the following devices available or unavailable to the system:
●
Serial Port
●
Parallel Port
● All USB Ports
●
Front USB Ports
●
System Audio
● IDE Controller Security
●
SATA Controller Security
●
IEEE 1394 Controller
●
Network Controller
● SAS Controller
For each device, Device Available is the default setting and allows the operating system access
to the device. Device Hidden makes the device unavailable. It is disabled by the BIOS and cannot
be enabled by the OS.
Enables a Network Service Boot which boots using the NIC PXE option ROM. In this case, the
actual boot image resides on a remote server. When enabled, you can set the boot order of the
NIC PXE option ROM and you can force a network boot by pressing F12 during POST.
Asset Tag
A 16–byte string identifying the system.
Ownership Tag
An 80–byte string identifying ownership of the system. This tag is displayed on the screen during
POST.
Computer Setup (F10) Utility 27