HP xw4300 Service And Technical Reference Manual page 86

To install one to two SATA drives:
1. Disconnect power from the system
2. Select a drive bay in which to install the drive.
3. Push the drive into the selected bay until it snaps into place.
4. Connect the data cable 1 and power cable 2 to the hard drive.
5. Connect the data cable 1 from the hard drive to the serial ATA port 2. SATA0 port is shown in the following
illustration.
• Connect SATA 0 to SATA0 (P60).
• Connect SATA 1 to SATA1 (P61).
To install three to four SATA hard drives:
1. Follow the instructions for installing two SATA hard drives
2. Follow the instructions for installing the hard drive into the optical drive slot
NOTE: If installing three SATA hard drives, you must install hard drives in at least one optical drive bay. If installing four
SATA hard drives, you must install hard drives in at least two optical drive bays.
3. Attach the power and data cable to the drive.
• Connect SATA 2 to SATA2 (P62).
• Connect SATA 3 to SATA3 (P63).
86 Removal and Replacement Procedures
(section 4.2) and open the access panel
(page
(section 4.9).
86).
(page 87).