Tools And Software Requirements - HP xw4300 Service And Technical Reference Manual

• Place reusable electrostatic-sensitive parts from assemblies in protective packaging or conductive foam.
Personal Grounding Methods and Equipment
Use the following equipment to prevent static electricity damage to equipment:
• Wrist straps are flexible straps with a maximum of one-megohm ± 10% resistance in the ground cords. To
provide a proper ground, wear the strap against bare skin. The ground cord must be connected and fit snugly
into the banana plug connector on the grounding mat or workstation.
• Heel straps, toe straps, and boot straps can be used at standing workstations and are compatible with most types
of shoes or boots. On conductive floors or dissipative floor mats, use them on both feet with a maximum of one-
megohm ± 10% resistance between the operator and ground.
Table 4-7 Static Shielding Protection Levels
Method
Antistatic plastic
Carbon-loaded plastic
Metallized laminate
Grounding the Work Area
To prevent static damage at the work area:
• Cover the work surface with approved static-dissipative material. Provide a wrist strap connected to the work
surface and properly grounded tools and equipment.
• Use static-dissipative mats, foot straps, or air ionizers to give added protection.
• Handle electrostatic sensitive components, parts, and assemblies by the case or PCB laminate. Handle them only
at static-free work areas.
• Turn off power and input signals before inserting and removing connectors or test equipment.
• Use fixtures made of static-safe materials when fixtures must directly contact dissipative surfaces.
• Keep work area free of nonconductive materials, such as ordinary plastic assembly aids and Styrofoam.
• Use field service tools, such as cutters, screwdrivers, and vacuums, that are conductive.
Recommended Materials and Equipment
Materials and equipment that are recommended for use in preventing static electricity include:
• Antistatic tape
• Antistatic smocks, aprons, or sleeve protectors
• Conductive bins and other assembly or soldering aids
• Conductive foam
• Conductive tabletop workstations with ground cord of one-megohm ± 10% resistance
• Static-dissipative table or floor mats with hard tie to ground
• Field service kits
• Static awareness labels
• Wrist straps and footwear straps providing one-megohm ± 10% resistance
• Material handling packages
• Conductive plastic bags
• Conductive plastic tubes
• Conductive tote boxes
• Opaque shielding bags
• Transparent metallized shielding bags
• Transparent shielding tubes

4.1.3 Tools and Software Requirements

• Torx T-15 driver or flat-bladed screwdriver
• Phillips screwdriver
• Diagnostics software
Voltage
1,500
7,500
15,000
51