HP xw4300 Service And Technical Reference Manual page 121

Table 5-18 POST Error Messages (continued)
Screen Message
207—ECC Corrected Single Bit
Errors in Memory Socket(s) y,y
212—Failed Processor
213—Incompatible memory
Module in memory Socket(s)
X,X, X
214—DIMM Configuration
Warning
215—Memory Mismatch
Warning
301—Keyboard Error
303—Keyboard Controller Error I/O board keyboard controller.
304—Keyboard or System Unit
Error
402—Parallel Port 2 Address
Assignment Conflict
501—Display Adapter Failure
510—Splash Screen image
corrupted
511—CPU0 or CPU1 Fan not
detected
512—Chassis, rear chassis, or
front chassis fan not detected
601—Diskette Controller Error
605—Diskette Drive Type Error
Probable Cause
Single Bit ECC error.
Processor has failed to initialize.
A memory module in memory socket
identified in the error message is missing
critical SPD information, or is
incompatible with the chipset.
DIMMs not installed correctly (not
paired correctly).
There are one or more mismatched pairs
of DIMMs between channel A and
channel B. Some memory has been
disabled. Install matching pairs.
Keyboard failure.
Keyboard failure.
IRQ address conflicts with another
device.
Graphics display controller.
Splash Screen image has errors.
Fan is not connected or might have
malfunctioned.
Fan is not connected, might have
malfunctioned.
Diskette controller circuitry or diskette
drive circuitry incorrect.
Mismatch in drive type.
Recommended Action
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace memory module if problem persists.
1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace memory with a module conforming to the
SPD standard.
Refer to section 4.19 "Memory" for the correct memory
configurations and reseat the DIMMs accordingly.
Refer to section 4.19 "Memory" for the correct memory
configurations and reseat the DIMMs accordingly.
1. Reconnect keyboard with workstation turned off.
2. Check connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
1. Reconnect keyboard with workstation turned off.
2. Replace the system board.
1. Reconnect the keyboard with workstation turned off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
Reset the IRQ.
1. Reseat the graphics card (if applicable).
2. If using PCI Express card with auxiliary power
cable, be sure it is attached.
3. Clear CMOS.
4. Verify that the monitor is attached and turned on.
5. Replace the graphics controller.
Install latest version of ROMPaq to restore image.
1. Reseat fan cable.
2. Reseat the fan.
3. Replace the fan.
1. Reseat chassis, rear chassis, or front chassis fan
cable.
2. Reseat chassis, rear chassis, or front chassis fan.
3. Replace chassis, rear chassis, or front chassis fan.
1. Run Computer Setup (F10 Setup).
2. Check and replace cables.
3. Clear CMOS.
4. Replace diskette drive.
5. Replace the system board.
1. Run Computer Setup (F10 Setup).
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear CMOS.
121