Advertisement
Available languages
Available languages
Assembly instructions GB
1 x anti tip
1 x screw
M6X20
1 Push the anti-tip into the sleeve of the
wheelbase.
2 Make sure that the position of the anti-tip
responds with the measuring scale on the
wheelbase.
3 Insert the screw and the washer. Tighten
the screw with a 4 mm Allen key.
4 There should be a maximum of 35 mm
from the end of the anti-tip to the surface.
To adjust this, loosen the screw (A) with a
4 mm Allen key. Push/pull the anti-tip to
desired position. Re-tighten the screw.
Assembling the anti tip on the left side of
the chair
As a standard the right hand side anti tip is
delivered. In order to use the anti tip on the
left hand side you have to do the following
before assembling.
Use a 5 mm Allen key to screw out the
A
B
C
1 x washer M6
screw (A). Remove the
spiral spring (B). Turn
around the fastening
bracket (C).
Assemble the spiral
spring and retighten the
screw.
1
2
3
4
A
Advertisement
