HP Visualize c160 Owner's Manual page 143

Perform the following steps to add memory modules to your workstation.
1 Remove the main tray assembly according to the directions in "Removing the
2 Use Figure 40 to locate the memory modules on the CPU Assembly.
0A
4A
0B
4B
2A
5A
2B
5B
3A
1A
3B
1B
Rear of Main Tray
Figure 40
NOTICE: Memory slots must be filled in order from 0A and 0B through 5A and 5B.
Main Tray Assembly" earlier in this appendix.
C160/C180/C200/C240 Memory Module Location
This workstation has 12 memory slots, labeled 0A, 0B through 5A, 5B. The
memory configuration is 32 MB to 1.5 GB installed in pairs of 16 MB, 32 MB,
64 MB, or 128 MB memory modules.
Memory modules must be installed in pairs of equal capacity.
Always install the largest capacity memory modules in the lowest numbered
memory slots.
For example, if you have a pair of 16 MB memory modules and a pair of 64 MB
memory modules, first install the pair of 64 MB memory modules in slots 0A
and 0B, then install the 16 MB modules in slots 1A and 1B.
Changing Your Workstation's Hardware Configuration
Installing Additional Memory
127