HP Visualize c160 Owner's Manual page 187

1 Write in the type of each device currently connected to your system under the
2 Add your new drive to the table.
3 Check to see what SCSI device IDs are not used. You may use ID numbers 0
CAUTION: Do not use SCSI device ID 7 for any device.
Table 29 Ultra, Wide SE SCSI Device Drives and Device ID
Ultra, Wide SE SCSI Device Drives
1st Internal Device
2nd Internal Device
1st External Device
2nd External Device
NOTICE: You can have no more than 4 SCSI devices connected to a ultra, wide SE bus.
heading "Ultra, Wide SE SCSI Device Drives" and each drive's SCSI device ID
under the heading "Device ID."
through 6 and 8 through 15 if they are not already in use. If the default ID on your
drive does not conflict with any existing drive IDs, use that ID. If your default
address conflicts with an existing drive ID, assign a new ultra, wide SE SCSI de-
vice ID to your drive. Refer to the drive's installation documentation for informa-
tion on changing the device ID.
______________________________
______________________________
______________________________
______________________________
SCSI Connections
Assigning SCSI Device IDs
Device ID (Address) Number
(ID 7 not available)
__________
__________
__________
__________
171