Advertisement
There is a risk to life if these safety
instructions are not observed!
• The LH200 may no longer be used
even in the case of very minor faults.
• Damaged, fall-stressed or dubious
equipment must be immediately with-
drawn and not used. Inspections may
only be carried out by BORNACK or an
expert briefed by BORNACK about the
inspection, including the corre-
sponding certificate. This must be
documented in the test card.
• Independent modifications or repairs
are not allowed.
• The LH200 may only be used by
trained staff that are familiar with the
material. They must be proficient in
handling the device and must have
been briefed about the possible risks
associated with its use.
• If it is no longer possible to position
the load in a controlled manner, the
device needs to be serviced by the
manufacturer.
• When operating the LH200 in areas
where there is a risk of falls, the oper-
ator must wear fall protection equip-
ment.
• Health impairments can jeopardise
the safety of the user when working at
heights or depths.
SAFETY REGULATIONS
• Protect equipment during storing, use
and transportation against the effects
of heat (e.g. welding flames or sparks,
burning cigarettes) and chemicals (e.g.
acids, alkalis, oils) and mechanical
impact (e.g. sharp edges).
• The local safety guidelines (e.g. in
Germany, the DGUV Regulations
112-198 and 112-199 issued by the
professional associations) and the
accident prevention guidelines for the
specific industry (UVV) must be
observed.
20 | 21
Advertisement
