tams elektronik BiDiBooster Manual page 19

BiDiBooster
Check that the pin assignment of the control unit´s booster interface
corresponds to that of the booster.
If you want the control unit to switch off the booster when a short
circuit occurs, you have to connect the short circuit feedback line. If
you do not connect the short circuit feedback line, the booster will be
switched off automatically when a short circuit occurs and automatically
on again after a set time.
Connection C: BiDiB-port (RJ 45)
Via the connection C (optionally C1 or C2) you can connect the
BiDiBosster with RJ 45-cables to the BiDiB interface of your control unit
or a PC interface with track output.
Hint: If necessary you have to mount the terminating jumpers
(→ section 6.1).
Please note:
!
Some control units have RJ 45 ports, but are not designed for the
connection of BiDiB-devices. When using these for the connection of
the BiDiBooster, damages at one or both devices possibly occur.
Hint: For the sake of clarity, we recommend to use different coloured
patch cables for different types of bus lines, e.g.

green for the BiDi bus

blue for the s88 bus

red for the data bus of the digital control
English
Page 19