Connecting The Control Unit - tams elektronik BiDiBooster Manual

English

6.2. Connecting the control unit

For the connection to the control unit you can use either

the DCC booster port (connection A) or

the BiDiB port (connection C).
In state of delivery the BiDiBooster is set to the use of the DCC-
conforming port. When you want to use the BiDiB port, you have to
alter the settings (→ section 7).
Connection A: DCC-conforming (3-pole) port
Via the connection "A" you can connect the booster either to

the control unit´s DCC booster connection or

if the control unit does not have a DCC booster connection: the
control unit´s track output.
In order to connect the cables to the booster use the enclosed
connectors which are designed to screw on the cables.
Connections control unit
E Short circuit report wire
D ground / data (-)
C data (+)
Fig. 3: Connections
Page 18
BiDiBooster