Table of Contents
Advertisement
12.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
¡ The programme settings have
been adjusted.
Press and hold Memory 1 or
▶
Memory 2 for approx. 3 seconds.
Press Memory 1 or Memory 2 to
call up the saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note: To prevent creasing, take note
of the maximum load for the
→ "Programmes", Page 31.
Requirement: The laundry is pre-
pared.
→ "Laundry", Page 35
Open the door.
1.
Make sure that the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload .
▶
a The display shows either the pro-
gramme duration or the "Ready in"
time.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press Start/Reload .
1.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→ "Display", Page 25
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Reload .
5.
12.8 Cancelling the pro-
gramme
Press Start/Reload .
1.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→ "Display", Page 25
Open the appliance door.
2.
Remove the laundry → Page 37.
3.
12.9 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
12.10 Switching off the appli-
ance
Press
.
▶
operation en
37
Advertisement
Table of Contents
