Table of Contents
Advertisement
Fault
The drying time is too
long.
and the appliance is
not responding to op-
eration.
"Selfcleaning"
Water is leaking from
the appliance.
"Please fill refresher
tank"
Water overflows when
filling the water tank.
Cause and troubleshooting
Remote start is activated and the ambient temperature
is lower than 16 °C.
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 68
The ambient temperature is low and the base unit fil-
ter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 38.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 56.
3.
→ "Switching off the appliance", Page 37.
4.
→ "Switching on the appliance", Page 36.
5.
→ "Starting the programme", Page 37.
6.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 17
▶
The seal for the heat exchanger cover is dirty.
Clean the seal for the heat exchanger cover.
▶
→ "Cleaning the filter system on the base unit",
Page 38
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
The lever for the heat exchanger cover is not closed
correctly.
Ensure that the lever for the heat exchanger cover
▶
is closed correctly.
→ "Closing the base unit", Page 56
The water tank for the crease-removal function is
empty.
→ "Filling the water tank", Page 41.
▶
The water tank has been filled.
Note: The overflowing water is harmless.
Do not pour any more water into the water tank.
▶
Troubleshooting en
63
Advertisement
Table of Contents
