Installing Memory; Main Memory Modules - HP Vectra VE5 2 User Manual

3 Raise the front of the power supply and engage the hinge on the rear.
4 Lower the front of the power supply into position so that it rests on the front panel.

INSTALLING MEMORY

MAIN MEMORY MODULES

Your PC is supplied with main memory. If you need more main memory to run your application
software, you can install up to a total of 128 MB.
Main memory is available in modules of 4 MB, 8 MB, 16 MB, or 32 MB. You must install
identical modules in pairs in each bank.
Banks A and B will take 4 MB, 8 MB, 16 MB or 32 MB modules. Use only 4 MB and 16 MB
modules in bank C, as 8 MB and 32 MB modules are not fully detected in this bank. 32 MB
modules are not available from HP. You can obtain 32 MB modules from your HP reseller.
CAUTION:
To install a main memory module:
1 Disconnect the computer's power supply cord and any connection to a
telecommunications network.
2 Remove the computer's cover and power supply.
3 Align the main memory module directly over the socket. Slide the memory module into the
slot at 45°. Firmly press the memory module completely into the connector.
Static electricity can damage electronic
components. Turn all equipment OFF. Don't let
your clothes touch the accessory.To equalize the
static electricity, rest the accessory bag on top of
the power supply while you are removing the
accessory from the bag. Handle the accessory as
little as possible and with care.