Table of Contents
Advertisement
SuperServer 5019D-FN8TP User's Manual
LAN Activity LED Headers
JTGLED1 is the activity LED header for LAN7 and LAN8, and JTGLED2 is the activity header
for LAN5 and LAN6.
SATA Ports
Twelve SATA 3.0 ports, supported by the Intel SoC chipset, are provided on the
X11SDV-8C-TP8F motherboard. These SATA ports support RAID 0, 1, 5, and 10. SATA ports
provide serial-link signal connections. Two additional SATA connections are availabe via the
M.2 connector. Refer to the table below for pin definitions.
M.2 Connection
The X11SDV-8C-TP8F board has two M.2 connectors at JMD1 and JMD2. JMD1 supports
M-Key 2280 and is mux with S-SATA5 while JMD2 supports B-Key 3042 and is mux with
S-SATA4. M.2 was formerly Next Generation Form Factor (NGFF) and serves to replace mini
PCI-E and mSATA. M.2 allows for a greater variety of card sizes, increased functionality, and
spatial efficiency. The M.2 socket on the motherboard supports PCI-E 3.0 x4 (32 Gb/s) SSD
cards in the 2280 and 22110 form factors.
A
Holder
Locked position
C
Card Holder Mount
Locked position
Turn 90 degrees
with M.2 card
to lock
LAN Activity LED
Pin Definitions
Pin#
Definition
1
3V3 Stby
2
LAN5_ACT_N
3
3V3 Stby
4
LAN6_ACT_N
B
Holder
Mount
Turn 90 degrees
Locked position
to lock
D
Plastic screw
STOP
SATA 3.0 Port
Pin Definitions
Pin#
Signal
1
Ground
2
SATA_TXP
3
SATA_TXN
4
Ground
5
SATA_RXN
6
SATA_RXP
7
Ground
Press in here
Rectangle hole
on MB
A+B+C
B
A
38
LAN Activity LED
Pin Definitions
Pin#
Definition
1
3V3 Stby
2
LAN7_ACT_N
3
3V3 Stby
4
LAN8_ACT_N
Hole Location on the MB
M.2 Card 60
A+B+C
M.2 Card 80
A+B+C
M.2 Card 110
A+B+D
A+B+D
B
C
A
©
Copyright
2017 by Super Micro Computer, Inc. All rights reserved.
42
D
Advertisement
Table of Contents
