Table of Contents
Advertisement
CANFDNET-200U
High-Performance Dual-Channel Ethernet to CAN (FD) Converter User Manual
7.2 Configuration Parameters
Category
Basic information
Password operation
Network Settings
For all
Ethernet/Vehicle
Ethernet
Table 7.10 Configuration parameter description
Property Name
Default
CANFDNET-20
Device model
Firmware version
Hardware version
Equipment No.
CANFDNET-20
Equipment name
Current password
Whether to
change the
password
New password
Confirm the new
password
DNS1
192.168.0.1
DNS2
192.168.1.1
MAC address
DHCP enable
192.168.0.178
(Universal
Ethernet)/
IP
192.168.1.178
(vehicle
Ethernet)
Subnet mask
255.255.255.0
192.168.0.178
(Universal
Ethernet)/
Gateway
192.168.1.178
(vehicle
Ethernet)
This item cannot be changed.
0U
-
Current firmware version of the device, such as 1.00.00.
-
Current hardware version of the device, such as 1.00.00.
Device serial number. Each device has a different device serial
-
number. It is a 16-byte string.
Device name. The value can be changed, a maximum of 15
characters. ASCII characters can be used. Modifying this value is
0U
very useful for users to identify multiple devices on the same
network.
Before changing other items, you must enter the correct
88888
password. Use ASCII characters as the password. The password
can contain a maximum of 9 characters.
Only when you select "Yes", you can enter "New Password" and
No
"Confirm Password".
If "Whether to change the password" is "No", the password
cannot be changed. Used to enter a new password. The
-
maximum length of the password is 9 characters. For the
character range, see "Current Password" .
If "Whether to change the password" is "No", the password
cannot be changed;
-
Used to confirm the new password. The content must be
consistent with the "new password".
Preferred DNS server address.
Alternative DNS server address.
The MAC address is different for different devices. It can be
-
changed. The default MAC address can be restored.
After being enabled, the device will obtain information such as the
IP address, subnet mask, and gateway from the network. If it is
disabled, the user sets the IP address, subnet mask, and
No
gateway. Note: After confirming that there is a DHCP server on
the network, DHCP can be enabled. Normally, the router also has
the DHCP server function.
Do not enter X.X.X.0 or X.X.X.255. An IP address is an address
on a network assigned to a network device, and it is unique on
the same network.
The subnet mask is very important for the network. In the same
network, each IP address
and the subnet mask are equal to the obtained value. So, set
them correctly
"IP address" and "subnet mask".
Enter the IP addresses of the gateway or router in this network.
24
Parameter Description
©2021 Guangzhou ZLG Electronics Co., Ltd.
User Manual
Advertisement
Table of Contents
