ZLG CANFDNET-200U User Manual page 16

CANFDNET-200U
High-Performance Dual-Channel Ethernet to CAN (FD) Converter User Manual
Protocol Version 4 (TCP/IPv4)]. The page as shown in Figure 5.6 appears. Select [Use the following IP address],
and enter the IP address 192.168.0.55, the subnet mask 255.255.255.0, and the default gateway 192.168.0.1
(the DNS part can be left blank). Click [OK] on this page and on the "Local Area Connection Properties" page, and
wait until the system configuration is complete.
The second method is to change the IP address of the device. On the interface in Figure 5.4, change the [IP]
item in [General Ethernet] to the IP address of the same network segment as the PC. For example, if the IP
address of the PC is 192.168.7.115, the subnet mask is 255.255.255.0, and the default gateway is 192.168.0.1,
change [IP] of [General Ethernet] to 192.168.7.178, and change the device gateway IP to "192.168.7.1".
⚫
CAN(FD) parameters
For CAN(FD) normal communication, set the CAN(FD) baud rate to be consistent with that on the CAN-Bus
network. The device is configured as an ISO CANFD controller by default. The baud rate of the arbitration domain
is 1 Mbps, and the baud rate of the data domain is 5 Mbps. To modify the data, adjust the arbitration domain baud
rate and data domain baud rate in the CAN0/1 configuration on the interface.
⚫
Work mode configuration
The factory work mode of the device is TCP Server mode, the port is 8000, and the network card is universal
Ethernet. Click the attribute value of [CAN(FD) to Ethernet] on the interface. On the pop-up interface, view or
modify the work mode, as shown in Figure 5.7.
Figure 5.6 TCP/IP properties
13
©2021 Guangzhou ZLG Electronics Co., Ltd.
User Manual