Wiring - Adaptive Micro Systems FAST 350 User Manual

5. Assembly - ADD "YOUR SPEED" SIGN
Install the "YOUR SPEED" sign on the enclosure. For the RU2 Fast 350/360 you will notice
(2) tamper-resistant screws and (3) button-head screws running horizontally atop the face
of the sign. Remove screws (tamper-resistant tool is provided in your tool kit), affix the
"YOUR SPEED" sign being careful that it is face up, and tighten the screws. For the 375,
(4) tamper resistant screws and (6) button-head screws install the R2-1 "YOUR SPEED"
sign.

6. WIRING

Your FAST 350/360/375 comes equipped to be powered either 12 volts D/C or 100-277
volts A/C (50/60 Hz). The required voltage should be noted on the end of the power cord
that leads into the enclosure. If you are unsure what you've purchased, please contact us
before proceeding. Enlist the services of a licensed electrical contractor for installation
assistance if needed.
For A/C powered units the power cord exiting the back of the enclosure has three wires;
a WHITE = Neutral lead, BLACK = Line (Hot), and GREEN = Ground. Please be cautious and
take care to observe polarity of wires while installing. If optional Data Recording System is
purchased, an additional wire is included – WHITE = Data positive, BLACK = Data
Negative, GREEN = Data.
For D/C powered units WHITE = Positive, BLACK = Negative, and GREEN = Data (for the
optional data collection unit).
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Figure 3b
Internal Radar Gun swivels vertically
for diverse aiming options
Phone (800) 558-7022 | AdaptiveDisplays.com