Adaptive Micro Systems FAST 350 User Manual page 10

** Optional SLOW DOWN and Flashing Red & Blue Violator Alerts can be purchased and
activated at any time. Call Customer Service 866-982-2107 for pricing and information.
Notes:
• After this last "BL" screen, all of the violator alert settings have been saved even
after the sign is switched off. When the sign is turned on again, it will run thru
all of the modes and their speed settings for the operator to review.
• If desired, the sign can be pre-set at your base facility for transportation and
set-up at a different location.
• The violator alerts can be set in any order, but not at the same speed. If
attempted, this setting will skip to the next available number. To get the best
effect from the alerts, set the speeds at least 3-4 MPH difference. If you wish to
not use one of the violator alert settings, set the speed high, i.e. 97 MPH.
• Holding the button will scroll through the numbers faster for quicker setup. If
the desired setting is passed, the numbers will start over after 99.
• If using the optional key chain remote, the left button advances the numbers
while the right button reverses them.
• To start over, either turn off/on the sign with the power key OR when using the
key chain remote, hold the left button in for 3 seconds for a power reset.
After setting the clock, (see Section 11 "Setting the Clock & Timed Events") the
sign will revert back to Normal Mode (NM). If Violator Alert mode is desired, it
will have to be set to "VA" mode again.
Violator Alert Settings Summary
Push button until display shows "VA"
Wait five seconds for MS (Minimum Speed) to display
"MS" will display. Push the button to set the desired speed.
Wait five seconds for SL (SLOW DOWN) to display
"SL" is displayed. Push the button to set desired speed.
Wait five seconds for RB (Flashing Red & Blue) to display
"RB" is displayed. Push the button to set desired speed.
Wait five seconds for FL (Flashing Speed) to display
"FL" is displayed. Push the button to set desired speed.
Wait five seconds for BL (Blanking Speed) to display
"BL" is displayed. Push the button to set desired speed.
After five seconds the last speed sets and the display goes dark
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
"Blanking Speed"
Phone (800) 558-7022 | AdaptiveDisplays.com