Table of Contents
Advertisement
10. ADVANCED FEATURES
In addition to the standard features there are some advanced features available mainly for
trouble shooting.
To enter the Advanced Feature mode, turn the unit ON and press the programming button five
(5) times before the intensity number blinks. First an "A" will appear on the left digit and a
number on the right. Press the programming button until the appropriate number is shown for
that slot. Wait for a "B" to appear and repeat this for "C" and "D" as well. This will put you into
that mode until the unit is turned off and back on again. See below a list of codes and slots for
these advanced features.
A
B
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
Lower speeds of 5 mph are distracting in most applications but are desirable in some. As a
default, the display will only show down to 5 mph but down to 1 mph is available. Putting in
the minimum speed code will turn on and off the down to one mode. If after putting in the
minimum speed code, the display shows "S1" then the speed will show down to 1 mph. If "S5"
shows then the speed will only show down to 5 mph.
The display can show the "Slow Down" violator alert two ways. One is that only "Slow Down" is
shown if the vehicle speed is over that set speed. The other is that the "Slow Down" will show
and then the vehicle speed will display, alternating between the two until the vehicle slows
below the set speed. Both are very effective but one could be preferred above the other. The
default is just "Slow Down". To switch from one or the other, put in the code and if the display
shows "On" then only the "Slow Down" message will display. If after the code is put in and "Off"
shows then the display will alternate between "Slow Down" and their speed.
Demo Mode will allow you to select 1 of 6 Demo. The display will show DM for Demo Mode
and then a number. Change the number to the desired demo. Please note the sign when
turned off will not turn on back on Demo Mode, but normal operating mode.
1 = Counts up and down from 51 to 59 and flashes
Demonstrates Dimming Feature
Shows "Slow Down" Violator Alert
Shows "Red and Blue" Violator Alert
2 = Shows just "Slow Down" Violator Alert
3 = Shows just "Red & Blue" Violator Alert
4 = Counts up and down from 31 to 39 flashes
C
D
6
9
Minimum Speed Mode
7
1
Alternate Slow Down Mode
7
3
Demo mode (see further instructions)
7
5
Show Serial Number
7
9
Display Diagnostic Mode
8
1
Auto Intensity Diagnostic Mode
8
3
Turn On & Off Radar Acceleration Filter
8
7
Turn On & Off No Display Availability
8
9
Turn On & Off Set Time Availability
Minimum Speed Mode
Alternate Slow Down Mode
Demo Mode
Advertisement
Table of Contents
