Adaptive Micro Systems FAST 350 User Manual page 14

11. SETTING THE CLOCK AND TIMED EVENTS
Note: Unless the sign is to be powered on and off automatically at certain times, it is not
necessary to set the clock
The internal timer is a 24 clock used to turn off the display's system to extend battery
life or to prevent disturbing residents at late or early hours. This feature will not
take into account weekends, holiday or daylight savings time. The Set Time
function must first be "turned on" in order to set the On/Off times. See Section 10 –
Advanced Features, code 9989 to activate this function. Once the feature is activated,
you will see the following codes added to the startup display setting:
ST
EN
DS
OH
OM
FH
FM
HR
MN
Note: If you become lost while setting any of the numbers, the settings operate the
same as the display set. In other words, if any numbers are missed the first time around,
they will repeat again by holding in the pushbutton. Also, the power key can be cycled
on and off to start over from the beginning or the key chain remote option allows you
to advance or reverse all numbers using both of its buttons.
As an example, let's set the sign to operate only during normal to high traffic
hours (for conserving the battery) to run daily from 5:30 AM to 11:45 PM. The
current time is 8:17 AM. These would be the programming steps:
• Turn power on. After the brightness number changes, push the button and stop
on "ST", the "Set Time" mode. Push the button until the display shows
"EN" (Enable):
"OH" displays. Push the button to see 05 (hours) on the display
Wait five seconds for "OM" ("ON" Minute) to display. "OM" is displayed. Push
Wait five seconds for "FH" ("OFF" Hour) to display.
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
TIMER CODE CHART
=> "Set Time"
=> "Enable"
=> "Disable"
=> "On Hour"
=> "On Minute"
=> "Off Hour"
=> "Off Minute"
=> "Hour"
=> "Minutes"
SETTING THE EVENT TIMER
Wait five seconds for "OH" ("ON" Hour) to display.
the button to see 30(minutes)
Phone (800) 558-7022 | AdaptiveDisplays.com
Time Set Menu
Turn on the timer feature
Turn off the timer feature
ON
Hour at which sign is to turn on
Minute at which sign is to turn
OFF
Hour at which sign is to turn off
Minute at which sign is to turn
TIME
Set current time hour (24 hour) Set
current time minute