Table of Contents
Advertisement
2
Safety information
WARNING
Applicability: Class B digital devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
WARNING
Applicability: Digital devices subject to 15.19/RSS-GEN.
NOTICE: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions:
1.
this device may not cause harmful interference, and
2.
this device must accept any interference received, including interference that may cause undesired
operation.
WARNING
Applicability: Digital devices subject to 15.21.
NOTICE: Changes or modifications made to this equipment not expressly approved by FLIR Systems
may void the FCC authorization to operate this equipment.
WARNING
Do not use screws that are too long. The depth of the holes in the camera is 4.0 mm (0.16 in) and 5.5
mm (0.22 in), see , page . Damage to the camera will occur if you use screws that are too long.
CAUTION
Do not point the infrared camera (with or without the lens cover) at strong energy sources, for example,
devices that cause laser radiation, or the sun. This can have an unwanted effect on the accuracy of the
camera. It can also cause damage to the detector in the camera.
CAUTION
Do not use the camera in ambient temperatures higher than +40°C (+122°F), unless other information
is specified in the user documentation or technical data. High temperatures can cause damage to the
camera.
CAUTION
The surface of the camera becomes hot. Use protective equipment when handling the camera in ambi-
ent temperatures higher than +40°C (+122°F).
CAUTION
Do not apply solvents or equivalent liquids to the camera, the cables, or other items. For cleaning, refer
to 12 Cleaning the camera.
CAUTION
Do not use too much force when you clean the infrared lens. Damage to the infrared lens or to the anti-
reflective coating of the lens can occur. For cleaning, refer to 12 Cleaning the camera.
#T810485; r. AA/76994/76994; en-US
2
Advertisement
Table of Contents
