Reservoir Calibration - Smeg SO6104S4PN Manual

You can also use a cleaning solution
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
15. Touch the CONFIRM
16. Shake the loading wand in order to remove
any remaining water.
17. Place the loading wand back in its holder.
18. Remove the jug (or container).
19. Drain the water from the jug.
20. Close the door.
Sanitization
Sanitization with steam allows to remove the last
residues of descaling from the hydraulic circuit.
1. set a 70% combined steam function lasting
at least half an hour.
2. Fill the jug with clean water.
3. Open the appliance door.
4. Rest the jug on the open door.
5. Remove the loading wand from its holder.
6. Place the end of the tube at the bottom of
the jug (or container).
7. Press the start
appliance reservoir with water.
8. When finished, shake the loading wand to
remove any water residue.
9. Place the loading wand back in its holder.
10. Remove the jug (or container).
11. Close the door.
12. Touch the START
selected steam function.
13. Wait for the function to be executed until the
end.
14. At the end of the function, drain the reservoir
as described above.
15. Wait for the end of the drain flow.
16. Drain the water from the jug.
Take care: wait for the oven cavity to
cool down.
17. Open the door.
18. Wipe off any spillage of water in the oven
cavity with a cloth or sponge.
19. Close the door.
118 - CLEANING AND MAINTENANCE
button.
button to start filling the
button to start the

Reservoir calibration

This function allows you to calibrate the
correct reading of the quantity of water
(or other liquid) inside the reservoir.
Over time, the quantities of water in the reservoir
may not be read correctly by the appliance
sensor. In this case, the functionality of the
appliance sensor can be restored to an optimal
condition.
Preliminary operations
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the RESERVOIR CALIBRATION
button (positioned in the lower area
).
Empty reservoir calibration
1. Open the appliance door.
2. Place an empty jug on the open door.
3. Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
4. Pull out the wand and dip the end into the
bottom of the empty jug.
5. Press the START
the water left in the jug.
6. Wait for the end of the drain flow.
button (located in
).
on the
button to start draining
914779723/A
).