FUTABA T16IZ Setting Manual page 9

Config 6/7 Holding Power
Decreasing the value weakens the holding power and makes the operation feeling closer to the normal
mode.
The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter.
between them. You can set the holding power rate selector switch to the channel with the AFR function of
the transmitter, and set the point for each rate on the AFR point curve to switch. It is also possible to use
Config 6/7
W i t h t h e s w i t c h b u t t o n , t h e
"holding power" of each rate (C1 to
C5) can be displayed and adjusted.
When set to SW of DG1 or DG2
When set to dial or lever
Config 7/7 Reset
Config Config
C1-C5 switch
button
Display and adjust the current rate
numbers C1 to C5 by operating
the channel on the transmitter.
C1
C5
-100%
-100% -75%
C1
100%
0%
-100%
9
S.BUS Basic 2/3
By operating the channel of the
transmitter, the channel position
of the current rate numbers C1
to C5 will be displayed in green.
Switch channel rate
-35% 0%
C1
Channel rate
-25% 0% 25%
C2 C3
Reset each Config item. It returns to the initial
value.
35% 100%
C5
75% 100%
C4 C5