Table of Contents
Advertisement
PROGRAM TX4UNI
Insert radio module on designated pins, if not pre-installed.
The receiver has two channels CH1 and CH2.
The respective LEDs CH1 and CH2 are assigned to these two
channels.
Receiving a signal from a programmed remote control button, CH1= P1
opens the gate partially.
Receiving a signal from another programmed remote control button,
CH2 = P2 fully opens the gate.
Program the remote control using button P2
(fully opens the gate, shown adjacent):
1. Insert jumper "Radio"
2. Press and hold left and right button of the remote control
simultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds. Now select one of 4 buttons
you wish to operate the gate with (do not press yet).
3. Press button P2. LED CH2 comes on for approx 10 seconds.
4. Within these 10 seconds
- press now the previously selected button of the remote control
- as control board and remote control are now going to adjust a
matching code, the button on the remote control must be possibly
pressed a second or third time.
- Once LED CH2 has flashed twice proceed with step 5.
5. Press one of the remaining 3 buttons of the remote control to end
programming using P2.
Note: If step 4 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 2.
Up to 180 remote controls can be programmed likewise.
In case no remote control is to be be programmed with
button P1, the jumper "RADIO PROGRAM" must now be removed.
Program the remote control using button P1
(partially opens the gate):
1. Press and hold left and right button of the remote control
simultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds. Now select another button
of the remote control to operate only one wing (do not press yet).
2. Press button P1. LED CH1 comes on for approx. 10 seconds
3. Within these 10 seconds
- press now the newly selected button of the remote control
- as control board and remote control are now going to adjust a
matching code, the button on the remote control must be possibly
pressed a second or third time.
4. Once LED CH1 has flashed three times proceed with step 4.
4. . Press one of the remaining 3 buttons of the remote control
to end programming.
Note: If step 3 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 1.
Up to 180 remote controls can be programmed likewise.
5. . Remove jumper "RADIO"
DELETE
1. Insert (connect) Jumper "Radio"
2. Press and hold buttons P1 (for CH1) or P2 (for CH2) until the
respective LED goes out again (approx. 10 seconds).
Single remote controls can not be deleted. All remotes programmed
to this channel are deleted.
Important: To finish deleting, remove jumper "Radio".
1
P1
2
3
P2
P1
RADIO
1/2 MOTOR
STOP/8.2KΩ
OPEN/PED
JP1
JP2
4
P2
P1
3x
5
P2
P3
RADIO
P3
CH1
CH2
P3
RADIO
CH1
CH2
1/2 MOTOR
STOP/8 2KΩ
Advertisement
Table of Contents
