Table of Contents
Advertisement
TYPICAL CONFIGURATION OF A UNIT:
1. Motor
2. Control board
3. Photocell (active for closing), max. height 200 mm
First photocell.
4. photocell (active for opening and closing), max. height 200 mm
Second photocell (optional).
5. Flashing light (optional)
Important visual information on the movement of the gate.
6. Key-operated switch or wireless keypad (optional)
Is mounted on the outside. The gate is opened by key or by
entering a number.
7. Contact strip (optional)
Safeguards the gate on being touched. Contact strips can be
mounted on the gate or on the pillars. If required, contact strips
must be mounted at a height of up to 2.5m.
The control board complies with the latest EU
guidelines. One of these guidelines specifies that the
closing forces at the gate edge must not exceed 400 N (40 kg) for
the last 500 mm before the door is CLOSED. Above 500 mm, the
maximum force at the gate edge must not exceed 1400 N (140
kg). If this cannot be ensured, a contact strip must be mounted on
the gate at a height up to 2.5 m or on the pillar on the opposite
side (EN12453).
Note: The listed accessories on page 2 are especially suited for the professional installation of a gate system.
INSTALLATION OF CONTROL BOX
Find the following parts in the control box:
- Exterior installation box
- Cover for box
- Control
- Transformer
- Baseplate (pre-assembled) 1
- Cable bushing large
- Cable bushing small
- Fastening clips
- Screws 3,5x 9,5 mm
- large closure screws
PREPARING THE CONTROL BOX
Open the 4 pre-cut holes at the bottom of the casing
with a screwdriver or a similar device.
Attach large cable bushing on the left then the rest
as shown in picture.
Humidity and water destroy the control. All openings
and cable bushings must be sealed against water
(waterproof). The control box with the motor control
is to be mounted with the cable bushings facing
down.
1
1
1
1
1
3
5
16
4
4
+
Advertisement
Table of Contents
