Page 1
. p r o l i g h t . c o . u k CARBON order code: EQLED22 user manual w w w . p r o l i g h t . c o . u k...
Page 2
Equinox Carbon Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
Page 3
Equinox Carbon Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
Page 4
Equinox Carbon Technical specifications You should find inside the Equinox carton the following items: 1, Carbon Unit 2, Power cable 3, Instruction manual Technical Specifications: Voltage: AC 230 ~ 50Hz 192 Ultra bright 10mm LED’s (R: 72, G: 48, B:72)
Page 5
Equinox Carbon Operation Operation: There are 5 different operation modes to choose from: 1) Built-in programmes 2) Auto run 3) DMX control mode 4) Sound Activated 5) Master/Slave mode 1, Selecting Built-in programmes Mode button - By pressing the “MODE” button under the LED display, the LED display will show “PRXX”, then you can select any of the prorgammes using the “UP”...
Page 6
Equinox Carbon Operation DMX Value/Function Channel 1 Channel 2 Channel 3 Function Speed Flash value Not used Not used 1-14 Programme 1 15-29 Programme 2 Programme 3 30-44 45-59 Programme 4 60-74 Programme 5 Programme 6 75-89 90-104 Programme 7...
Page 7
DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Carbon can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
Page 8
Equinox Carbon DMX Set up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.
Need help?
Do you have a question about the CARBON and is the answer not in the manual?
Questions and answers