Advertisement
R&S Scope Rider RTH Digital Oscilloscope
Version
Function
1.30.3.5
Configuration of cursors and measurements does not interrupt and restart acquisition
anymore. Configuration can be done while acquisition continues running.
1.30.3.5
Display menu: new configuration window for intensity. Can be used to configure the intensity
of the displayed waveforms (scope mode only).
1.30.3.5
STOP mode: increased reactivity when changing parameters such as vertical or horizontal
settings or zoom.
1.20.3.4
Option B1, protocol trigger: setting of the thresholds in the protocol menu is now independent
of the trigger level that is currently applied.
1.20.3.4
RTH1002: PT1000 platinum temperature sensor was removed from the menu, as this
accessory is not supported by the instrument. Only PT100 and PT500 are supported.
1.10.2.10
Selfalignment extended by DMM section for RTH1002:
For RTH1002, scope mode: selection between scope vertical alignment only and all scope
and DMM alignment steps ("full").
For RTH1002, DMM mode: selection between DMM alignment only and all scope and DMM
alignment steps ("full").
1.10.2.10
To restore the factory settings, hold down the PRESET key during the boot process.
Improved: the PRESET key can be released once the pop-up window appears where the
restore has to be confirmed or cancelled. It is not necessary anymore to keep the PRESET
button pressed all the time.
1.0.1.19
Demo K0 enables all K-options and B1 option.
1.0.1.19
Selftest reworked: all visible test steps are able to run; test steps that are not implemented or
require user interaction were removed from the list of selectable test steps.
0.90.8.30
None, as this is a first release
5 Eliminated Issues
The following table lists the eliminated issues and indicates the version in which the
issue was eliminated:
Release Notes 1326.2645.00 - 5
6
Advertisement
