Electrical Specifications - HP Kayak XU Technical Reference Manual

Parameter
Input voltage
Input current (max)
Output power
Input frequency
Available power
Max current at +12 V
Max current at -12 V
Max current at +3.3 V
Max current at +5V
Max current at -5V
Max current at +5Vstb
NOTE
1 System Overview
Specifications and Characteristic Data

Electrical Specifications

Total Rating
100-127
Vac
7,5 A
260 W
47 Hz to 63 Hz
260 W
8 A
0.5 A
30 A
30 A
0.1 A
250 - 300 mA
An attempt to draw too much current (such as a short circuit across edge-
connector pins, or an accessory board that is not suitable for these PC
Workstations), will cause the overload protection in the power supply to be
triggered, and the PC Workstation could fail to boot.
When the PC Workstation is turned off with the power button on the front
panel, the power consumption falls below 5 Watts, but is not zero. The special
on/off method used by this PC Workstation extends the lifetime of the power
supply. To reach zero power consumption in "off" mode, either unplug the PC
Workstation from the power outlet or use a power block with a switch. You
should be aware that the PC Workstation will lose its time settings within a
few days if you unplug the PC, or switch off the PC Workstation at the power
block.
4
Notes
Accessory
200-240 Selected
Vac automatically
3,75 A
Less than 5 W
when turned
off
25 W (max)
—
—
Together, these
two must not
exceed 170 W
—
—
Typical Typical
per PCI per ISA
for AGP
Accessory
Slot Slot
15 W (max)
0.5 A 0.2 A
0.1 A 0.5 A
7.6 A
—
5 A 1 A
0.2 A
—
— —
Max.
Slot
80 W
(max)
1 A
19 A
2 A