Figure 16. E-Pac Installation - HP i2000 Hardware Installation

9. Once the E-PAC is in place, close the power supply door by disengaging the
power supply door-locking tab located near the I/O board. The supply closes in a
downward motion into the system. While closing, keep the cables of the power
supply in channel of the E-PAC as much as possible. Be sure that no power cables
are being cut or pinched and DO NOT FORCE the door closed. If the system will
not close easily, then the cables of the power supply need to be routed back into
the E-PAC channel.
10. Reattach the two- (2) power supply door screws.
11. Reattach the side panel by placing the tabs of the sheet metal into the slots of
the system at the top. Then slide the side panel towards the front of the system.
When properly in place, the lock can be depressed into the system and secured.
12. Reattach the bezel by aligning the top of the bezel to the top of the system.
Then by aligning the interlock clips with their respective slots push the clips into the
slots starting with the top two down to the bottom clips.
13. Reattach all external devices such as the keyboard, mouse, video monitor and
AC power into their respective ports.
14. The system is now ready to power on.
22

Figure 16. E-PAC Installation

hp workstation i2000
Center Tab