2. Carefully place the system on its side. The side containing the lock in the center
should be facing upwards.
3. Pull the system out from the work area and grasp the bottom inside of the bezel.
Locate the two- (2) bezel clips (as show in Figure 2) near the bottom of the system
and press in to disengage the bezel from the chassis sheet metal. Once
disengaged, gently pull the front bezel away from the system. There are four- (4)
interlock clips that disengage from the slots within the system chassis.
4. Remove the side cover by firmly pressing on the center of the panel and pushing,
forcing the panel to slide backwards toward the rear of the unit.
Figure 2. Bezel Interlock Clips
hp workstation i2000
Bezel Interlock Clips
11