Installing An Itanium Processor In An Hp Workstation I2000; Removing The Processor; Figure 7. Processor Assembly - HP i2000 Hardware Installation

installing an Itanium    processor in an hp
1.2
workstation i2000
NOTE
Due to differences, such as stepping core speed and internal cache processor part
numbers must match in a dual processor configuration. Attempting to operate with mixed
part numbers may cause system failure or unstable operation.

removing the processor

1.2.1
1. Remove the processor E-PAC from the processor assembly.
2. Remove the four- (4) Phillips-head screws securing the processor Power Pod to
the retention device. Refer to Figure 7.
Processor
Power Pod
Power Pod Retaining
Screws. Four- (4)
total, two- (2) each
side at the "base" of
the pod.
1. After removing the four- (4) retaining screws from the base of the Power Pod,
set the screws safely aside.
2. Disengage the Power Pod from the processor by sliding it outward and away
from the processor (as shown in Figure 8).
Retaining Device

Figure 7. Processor Assembly

hp workstation i2000
Processor "Q"
Number
Processor Retaining
Nuts. Four- (4) total,
two- (2) each side
15