replacing the power pod
1.2.3
1. Locate the processor Power Pod and four- (4), (6-32 .5 inch) Phillips-head screws.
2. Place the processor Power Pod onto the retention device.
3. Next, firmly mate the Itanium processor card edge power connector to the
Power Pod's card edge socket.
Slide the Pod in this
direction to mate
4. Fasten the Power Pod to the retention device with four - (4) Phillips-head
screws. A second processor can be installed in a similar manner if required.
Figure 13. Installing the Power Pod
hp workstation i2000
19