Figure 4. Power Supply Door In Opened Position - HP i2000 Hardware Installation

Peripheral
Power
Harness
Baseboard
E-PAC

Figure 4. Power Supply Door in Opened Position

7. Open the power supply door (as shown in Figure 4) by pulling upwards and
allowing the door to swing outwards until the metal clip (near the top of the
system) is engaged with a "click". The power supply door is now locked into an
open position for system access.
8. Remove the baseboard E-PAC (black Styrofoam protective material as shown in
Figure 4).
NOTE
This E-PAC material is required for proper operation of the
system and must be replaced in the same position before
closing the system after servicing.
hp workstation i2000
Baseboard
Power Harness
Processor
E-PAC
13