815-Based Graphics Programming; Monitor Power Management Control; 815-Based Graphics; Table 6-3. Monitor Powerm - HP Deskpro EX Technical Reference Manual

Hp deskpro ex: reference guide
Table of Contents

Advertisement

6.3

815-BASED GRAPHICS PROGRAMMING

The 815-based graphics controller is configured using PCI configuration registers listed in Table
6-2.
Table 6-2. 815-Based Graphics Controller PCI Configuration Registers
815-Based Graphics Controller PCI Configuration Registers
PCI
Config.
Addr.
Register
00, 01h
Vendor ID
02, 03h
Device ID
04, 05h
Command
06, 07h
Status
08h
Revision ID
0A, 0Bh
Class Code
0Eh
Header Type
0Fh
BIST
10-13h
Memory Range Addr.
14-17h
Mem. Mapped Range Addr.
2C, 2Dh
Subsys. Vendor ID
NOTE:
Assume unmarked locations/gaps as reserved. Refer to Intel documentation for detailed
register descriptions.
The graphics controller is controlled through memory-mapped registers by the appropriate
software driver.
6.4

MONITOR POWER MANAGEMENT CONTROL

The controller provides monitor power control for monitors that conform to the VESA display
power management signaling (DPMS) protocol. This protocol defines different power
consumption conditions and uses the HSYNC and VSYNC signals to select a monitor's power
condition. Table 6-4 lists the monitor power conditions.
Table 6-3. Monitor Power Management Conditions
HSYNC
VSYNC
Active
Active
Active
Inactive
Inactive
Inactive

Table 6-2.

(GMCH, Function 2)
Reset
Value
8086h
1132h
0004h
02B0h
02h
0003h
01h
00h
8
0's
0000h
Table 6-4.
Monitor Power Management Conditions
Power Mode
Description
On
Monitor is completely powered up. If activated, the inactivity
counter counts down during system inactivity and if allowed to
tiemout, generates an SMI to initiate the Suspend mode.
Suspend
Monitor's high voltage section is turned off and CRT heater
(filament) voltage is reduced from 6.6 to 4.4 VDC. The Off mode
inactivity timer counts down from the preset value and if allowed
to timeout, another SMI is generated and serviced, resulting in
the monitor being placed into the Off mode. Wake up from
Suspend mode is typically a few seconds.
Off
Monitor's high voltage section and heater circuitry is turned off.
Wake up from Off mode is a little longer than from Suspend.
Compaq Deskpro EX Series of Personal Computers
First Edition - August 2000
Technical Reference Guide
PCI
Config.
Addr.
Register
2E, 2Fh
Subsystem ID
30-33h
Vid. BIOS Base Addr.
34h
Capabilities Pointer
3Ch
Interrupt Line
3Dh
Interrupt Pin
3Eh
Min. Grant
3Fh
Max. Latency
DC, DDh
Pwr. Mgmt. Capabilities
DE, DFh
Pwr. Mgmt. Capabilites
E0, E1h
Pwr. Mgmt. Control
E2-FFh
Reserved
Reset
Value
0000h
0's
DCh
00h
01h
00h
00h
0001h
0022h
0000h
--
6-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents