Serial Interface; Interface; Figure 5-3. Serial Interfacec; Table 5-7. Db-9 Serial Connector - HP Deskpro EX Technical Reference Manual

Chapter 5 Input/Output Interfaces
5.4

SERIAL INTERFACE

All models include two serial interfaces to transmit and receive asynchronous serial data with
external devices. The serial interface function is provided by the LPC47B357 I/O controller
component that includes two NS16C550-compatible UARTs.
Each UART supports the standard baud rates up through 115200, and also special high speed rates
of 239400 and 460800 baud. The baud rate of the UART is typically set to match the capability of
the connected device. While most baud rates may be set at runtime, baud rates 230400 and
460800 must be set during the configuration phase.
5.4.1 RS-232 INTERFACE
Each UART is associated with a DB-9 connector that complies with EIA standard RS-232-C. The
DB-9 connector is shown in the following figure and the pinout of the connector is listed in Table
5-5.
Figure 5-3. Serial Interface Connector (Male DB-9 as viewed from rear of chassis)
Table 5–7. DB-9 Serial Connector Pinout
Pin Signal
1 CD
2 RX Data
3 TX Data
4 DTR
5 GND
The standard RS-232-C limitation of 50 feet (or less) of cable between the DTE (computer) and
DCE (modem) should be followed to minimize transmission errors. Higher baud rates may require
shorter cables.
5-8 Compaq Deskpro EX Series of Personal Computers
Table 5-7.
DB-9 Serial Connector Pinout
Description Pin
Carrier Detect 6
Receive Data 7
Transmit Data 8
Data Terminal Ready 9
Ground --
First Edition – August 2000
Signal Description
DSR Data Set Ready
RTS Request To Send
CTS Clear To Send
RI Ring Indicator
-- --