HP Deskpro 1000 Reference Manual page 63

Battery Replacement Notice
Power Cord Set
Requirements
General Requirements
A-4 Agency Regulatory Notices
WARNING:
Your computer is provided with a battery-powered
!
real-time clock circuit. There is a danger of explosion and risk of
personal injury if the battery is incorrectly replaced or mistreated.
Do not attempt to recharge the battery, disassemble it, immerse it
in water, or dispose of it in fire. Refer to Appendix F for
replacement procedures.
For more information about real-time clock battery replacement or
proper disposal, contact your Compaq authorized reseller or
service provider.
The voltage select switch feature on the computer permits it to
operate from any line voltage between 100 to 120 volts AC or
between 200 to 240 volts AC.
The power cord set (flexible cord or wall plug) received with the
computer meets the requirements for use in the country where
you purchased the equipment.
Power cord sets must meet the requirements of the country
where you use the computer. For more information on power
cord set requirements, contact your Compaq authorized reseller
or service provider.
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet
(1.5 m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord set will be used.
3. The power cord set must have a minimum current capacity
of 10A and a nominal voltage rating of 125 or 250 volts
AC, as required by each country's power system.
4. The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet
C13 connector, for mating with appliance inlet on the rear
of the unit.