Installing a SIMM
5-6
Reference Guide
CAUTION:
When handling a memory module, be careful not to
touch any of the contacts. Doing so may damage the module.
1. Turn off the computer and disconnect the power cord from
the electrical outlet.
2. Remove the computer cover.
3. Insert a memory module at a 45-degree angle into a SIMM
memory module socket on the system board 1.
A memory module can be installed in only one way. Match
the notch on the module with the tab on the memory
socket. Push the module down into the socket, ensuring
that the module is fully inserted and properly seated.
Installing a SIMM Module
4. Rotate the module to an upright position, allowing the
latches to snap into place 2.
5. Repeat steps 3 and 4 for each module that you want to
install.