Troubleshooting - i-PRO WV-S22700-V2L Basic Information

Troubleshooting

Before asking for repairs, check the symptoms with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the
table or a problem is not described below.
Symptom
Power is not turned
on.
The LINK indicator
does not light in
orange even when the
Ethernet cable is con-
nected to the camera.
The SD indicator does
not light even when a
microSD memory card
is installed.
The SD memory card
warning/error indicator
blinks red
Cause/solution
When using a PoE device for power supply
• Are the PoE device (IEEE802.3af compliant) and the RJ45
Network connector connected using an Ethernet cable?
Check whether the connection is appropriately established.
• Depending on the PoE device, the power supply will stop
when the demanded power exceeds its total power limit
for all PoE ports.
Refer to the operating instructions of the PoE device in use.
When using DC power supply
• Is the power cord plug (accessory) firmly inserted into the
power supply terminal (12 V DC) of the camera?
Confirm the power plug is firmly connected.
• Is the AC adaptor in use compliant with the Specifications?
Check the Specifications regarding AC adaptor.
• Is the Ethernet cable connected appropriately?
Connect the Ethernet cable appropriately.
• Is the hub or router connected to the camera operating
appropriately?
Check if the hub or router in use is operating appropriately.
• Is the Ethernet cable connected to the camera broken?
Replace the cable with another one.
This indicator lights up green when the microSD
memory card is recognized correctly and ready for
use.
• Has the inserted microSD memory card been formatted
on a PC?
Use a microSD memory card formatted on the camera.
Or install the software to format the microSD memory
card on the PC.
Refer to our support website <Control No.: C0105>
for further information about the supported software.
• Is the inserted microSD memory card faulty?
Replace the card with a normal one.
• The read / write error on the microSD memory card has
occurred. Is the inserted microSD memory card faulty?
Replace the card with a normal one.
15
Reference
pages
Installation
Guide
11
12
12