i-PRO WV-S22700-V2L Basic Information page 11

■ Indicators and buttons
①
INITIAL SET button
⑦
TELE+AF button
227V2L
226V2L
225V3L
⑧
WIDE+AF button
227V2L
226V2L
⑥
225V3L
The above illustration represents WV-S22700-V2L
①
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an
external power supply, disconnect the power cord plug (accessory) from the power supply
terminal (12V DC).
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
•
When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor ⇔
PAL monitor.
②
LINK indicator
• When the camera is able to communicate with
the connected device
③
ACT indicator
• When data is being sent via the network camera
③
ACT indicator
②
LINK indicator
SD ON/OFF button
④
SD indicator
⑤
Lights orange
Blinks green (accessing)
11
SD memory card warning
/error indicator