Page 1
WIRELESS SHUTTER CONTROL KEY FOB Combination of iNELS Key Fob and shutter switching device to control garage doors, gates, blinds and awnings...
Page 2
The individual elements in the iNELS set are paired and their functions are preset. iNELS kit for shutters enables it´s remote control. DOWN/STOP UP/STOP shutters no.1 shutters no.1 DOWN/STOP UP/STOP shutters no.2 shutters no.2 The settings of the wall controllers can be changed - see detailed manuals of iNELS elements.
Page 3
Detailed manual Controller – key fob RF KEY-40 RF KEY 40/B – 4 button controller - keychain (remote control), black RF KEY 40/W – 4 button controller - keychain (remote control), white RF KEY 40 Characteristics • Key fob-sized remote control - used to control, lights, gate, garage door, shitters, etc. •...
Page 4
EN 60669, EN 300 220, EN 301489, Related standards: No 426/2000 Coll. Attention When you install iNELS RF Control system, you have to keep a minimal distance of 1 cm (0.4“) between each unit. Between the individual commands must be an interval of at least 1s.
Page 5
RFJA-32B-SL • The switching unit for blinds has 2 output channels used to control garage doors, gates, blinds, awnings, etc… • It can be combined with system components iNELS RF Control with RFIO protocol. • The BOX design lets you mount it right in an installation box, a ceiling or motor drive cover.
Page 6
Technical parameters RFJA-32B-SL Supply voltage: 230 V AC / 50 - 60 Hz φ Apparent input: 7 VA / cos = 0.1 Dissipated power: 0.7 W Supply voltage tolerance: +10 -15 % Output: Number of contacts: 2x switching (AgSnO Rated current: 8 A / AC1 Switching power: 2000 VA / AC1...
Page 7
Connection Indication, manual control •LED STATUS - indication of the device status. • Manual control is performed by pressing the PROG button. • Programming is performed by pressing the PROG button for more than 1s. • Terminal block for connection of buttons. IN1 - direction button up IN2- button down. In the programming and operating mode, the LED on the component lights up at the same time each time the button is pressed - this indicates the incoming command 1.
Page 8
Radiofrequency signal penetration through various construction materials Range up to 200 m in open space, if the signal is insuffi cient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO that supports this feature. 60 - 90 % 80 - 95 % 20 - 60 % 0 - 10 %...