Advertisement
- The Hybrid IP-PBX will continue to be powered even if the power
switch is turned "OFF".
- The power supply cord is used as the main disconnect device,
ensure that the socket-outlet is located/installed near the
equipment and is easily accessible.
1. Set the System Clear Switch to the "SYSTEM INITIALIZE" position.
2. Plug the AC power cord into the Hybrid IP-PBX and an AC outlet,
and turn on the Hybrid IP-PBX.
Note:
For safety reasons, do not stretch, bend, or pinch the AC power
cord.
3. Press the Reset Button with a pointed tool. (The RUN indicator
will flash.)
4. While the RUN indicator is flashing (within about 10 s), return the
System Clear Switch to the "NORMAL" position. Depending on
the configuration, initialization takes about 1 min to 3 min. If
successfully executed, the RUN indicator will stop flashing and be
kept lit.
All data will be cleared and the Hybrid IP-PBX will be initialized to the default values. The DPTs
should show the time as 00:00.
Note:
Use the AC power cord attached to the PSU only.
9
Advertisement
