Safety Notes; Installation Instructions; Symbol Description - Hans Grohe Talis S 160 Instructions For Use/Assembly Instructions

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the ixture must be installed, lushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 35)
To adjust the hot water limiter. Using a hot
water limiter in combination with a continu-
ous low water heater is not recommended.
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Assembly (see page 31)
English
Cleaning (see page 36)
Maintenance (see page 37)
The check valves must be checked regularly
according to DIN EN 1717 in accordance
with national or regional regulations (at least
once a year).
Test certiicate (see page 37)
Operation (see page 38)
• Do not rotate the spout further than 360º
• Hansgrohe recommends not to use as
Dimensions (see page 39)
Flow diagram (see page 39)


Spare parts (see page 40)
XXX = Colors
000 = Chrome Plated
800 = Stainless Steel Optic
Special accessories
(order as an extra)
service tool #95910000
or damage to the hose will result.
drinking water the irst half liter of water
drawn in the morning or after a pro-
longed period of non-use.
Normal spray
Regular