Canon PIXMA MP950 User Manual page 133

Note
Error Message On Camera
Printer in use/Printer warming up
No paper/Paper Error
Paper jam
Printer cover open
No print head
Chapter 12
PictBridge or Canon Bubble Jet Direct compatible digital cameras can be
connected to your machine for direct printing.
This section describes errors that are indicated on Canon-brand PictBridge-
or Bubble Jet Direct compatible cameras. The error messages and
operations may vary depending on the camera you are using. If you are using
a non-Canon PictBridge compatible camera and not sure how to clear the
printer error from the camera, confirm the message displayed on the LCD of
the machine and clear the error. For clearing an error from the machine, see
"An Error Message is Displayed on the LCD" on page
A communication time out occurs if printing takes a long time or if it takes too
much time to send data. This may stop printing. In such cases, disconnect
the cable between the machine and the camera, and reconnect the cable
between the machine and the camera. Then, turn the camera on, if it does
not automatically turn on. If the problem is still unresolved, select some other
photo and check if it can be printed or not.
Some PictBridge compatible devices may need to be switched to printing
mode before connecting them to the machine. Also, it may need to be turned
on manually or switched to replay mode after connected to the machine.
Refer to the instruction manuals supplied with your PictBridge compatible
device and take the necessary steps before connection.
The Print Head nozzles may be clogged if printing becomes faint or colors
are incorrect. See "When Printing Becomes Faint or Colors are Incorrect" on
page 102.
If the paper is curled or its surface is scratched during printing, make sure
that you are using the correct type of paper. If this error occurs even when
you are using the correct type of paper, see
resolved even after taking the actions above:" on page
For the errors indicated on the camera and their solution, also refer to the
user's manual of the camera. For other troubles with a digital camera, contact
the manufacturer of the camera.
Photos are printed from the computer.
Wait until printing ends. When it is ready, the machine starts printing
automatically.
Load paper in either the Auto Sheet Feeder or Cassette which you have
selected with [Feed Switch] on the machine, and select "Continue"
the display on your camera.
The camera does not support the page size that is selected on this
machine. Check the print settings and select the page size that is
supported by the camera.
Open the Paper Output Tray to resume printing. Close the Inner Cover if
it is open. Select "Stop" in the display on your camera to stop printing.
Select "Stop" in the display on your camera to stop printing.
Remove the jammed paper, load new paper, and press [OK] on the machine
and retry printing.
Close the Scanning Unit (Printer Cover) on the machine.
The Print Head is defective or not installed.
Install a Print Head according to the Easy Setup Instructions.
If the Print Head has already been installed, remove the Print Head and
reinstall it.
If the error still remains, the Print Head may be defective. Contact the
Canon Customer Care Center.
115.
"If printing surface abrasion is not
126.
Action
Troubleshooting
*1
in
131