Sena SRL-EXT User Manual page 16

2 INSTALLING THE HEADSET ON YOUR HELMET
12. After aligning the cables, attach the battery connector and the
cables with adhesive tape on the second cavity located at the rear of
the helmet.
Note: Do not cover the snap fastener with the aligned cables. Make
sure the aligned cables are placed above the snap fastener.
13. Peel off the cover of the hook and loop fastener for the speaker (R)
and the speaker pad to expose the adhesive surface. Then, attach
the fasteners to the ear pockets inside the helmet.
14. Attach the speaker (R) and the speaker pad to the hook and loop
fastener use for the speaker inside the helmet.
Note:
• In order to enjoy optimal audio quality, Sena recommends placing
the speakers as close as possible to your ears, using the thickest
pads.
• If you feel physically uncomfortable with the speakers when wearing
the helmet, you can try thinner pads or remove the speaker pads.
Second Cavity
SRL-EXT Motorcycle Mesh & Bluetooth Communication System for Shoei Helmets | 16
®