Sena SRL-EXT User Manual page 12

2 INSTALLING THE HEADSET ON YOUR HELMET
2. Insert the clamp's back plate into the clamp insertion position. Then,
remove the clamp guide sheet.
Clamp Insertion Position
3. Clean the area on the left side of your helmet where you will attach
the double sided adhesive tapes with moistened towel and dry
thoroughly.
4. Peel off the double sided adhesive tape to the back of the main unit.
5. Attach the main unit to the clamp, and attach the back of the main
unit to the left side of the helmet with double-sided adhesive tape.
Note: Make sure that the main unit is firmly attached to the helmet.
Maximum adhesion occurs after 24 hours.
6. Tighten the two screws until the main unit is firmly fastened to the
clamp.
SRL-EXT Motorcycle Mesh & Bluetooth Communication System for Shoei Helmets | 12
®